MM-5490D


2 GB Dual RACEway to PCI DRAM Memory Buffer

Features
Simultaneous access from multiple ports
Capacity: 452MB/s, 256MB, 512MB, 1GB, and 2GB, 4GB
Transfer Rate: RACEway=160 MB/s, PCI bus=132 MB/s
PCI DMA and initiator capabilities necessary to maximize read and write transfers
Supports PCI interrupts
VxWorks software configuration driver for SHARCs and PowerPCs are provided for Mercury’s MCOS
Single slot PCI board compatible with mother boards and passive backplanes
Battery backup
Description

The MM-5490D is a 2GB PCI DRAM memory buffer with six RACEway ports and a 32bit/33MHz PCI port for use in multi-processing applications with intensive data streaming requirements. The card is capable of simultaneous burst mode access providing an aggregate bandwidth of up to 452MB/s.

The MM-5490D can be placed at the front or rear end of a real time DSP system to buffer incoming and outgoing data. Individual compute nodes can then receive, process and transfer streaming data at will, which can greatly reduce total compute time for the DSP’s and arbitration and overhead for the host, improving overall system performance. The card also provides the benefit of being a gateway from RACEway into the PCI bus.

In addition to having a 32-bit/33MHz PCI port, the card has two RACEway ports Over-The-Top and four RACEway ports on the face of the board. Each of these four ports has an individual memory bank with up to 512MB of DRAM. Each memory bank can be accessed simultaneously, but only through its dedicated RACEway port.

Seven nodes on three RACEway crossbars and a RACEway PXB are utilized to deliver simultaneous access from the two over the top RACEway ports and the PCI. The PCI is capable of being both a target (slave) and a DMA initiator (master), in order to maximize read and write throughput over the bus.

Reliability is ensured by burn-in and running memory diagnostics that check operations for 48 hours while temperature-cycling boards between 0° to +60° C.

MM-5490D Specifications

bullet

Capacity : 256MB, 512MB, 1GB, and 2GB

bullet

Port Access : Simultaneous access from All ports

bullet

Compatibility : RACEway Specification Rev. 1.4
PCI Local Bus Specification Rev. 2.1, 32-bit/33MHz

bullet

Burst Mode Transfer Rate : Each RACEway port:160 MB/s
PCI:132 MB/s

bullet

Address : 32-bits for either RACEway and PCI

bullet

Data In/Data Out : 32-bits multiplexed for each RACEway port and PCI

bullet

Modes of Operation : Read, Write, and Refresh

bullet

Power Requirements : 5V @ 2.6 Amps Operating, 3.3V @ 1.0 Amps

bullet

Operating Temperature : 0° to +60° C

bullet

Storage Temperature : -40° to +85° C

bullet

Relative Humidity : Up to 95% without condensation